Olympia NC 450 Mode D'emploi page 14

When the bank notes counted are removed from the
output tray, the quantity count in the top display is reset
to X 0 and the bottom display displays the quantity.
Adding
If several bundles of bank notes are stacked in the in­
feed tray one after the other, counting continues even if
the bank notes already counted are removed from the
output tray.
Æ Press the ADD button
Ê The Add function is activated/deactivated.
Batch
This function causes counting to stop when the preset
quantity of bank notes has been counted. If the counted
batch of bank notes is removed from the output tray, the
display is reset to X 0 and the next batch is counted.
The quantity of bank notes can be set to any number
between 1 and 999 . The preset quantity appears in the
bottom display.
If the infeed tray becomes empty before reaching the
preset quantity, BATCH flashes in the display. When
more bank notes are then inserted in the infeed tray, the
process is resumed.
Æ Press the BATCH button.
Ê BATCH flashes in the display. The preset quantity
100 appears in the bottom display.
Æ Use the digit buttons to enter the quantity you want
counted.
Ê The quantity entered appears in the bottom display.
14
Sorting
With this function, which is always activated, the first
bank note is used as a reference for those following. If
the machine detects a bank note which deviates from
the reference note, the machine stops.
display, the background of which turns red. The deviat­
ing bank note can be removed.
Whether the removed bank note should be counted or
not can be defined in the settings (refer to Settings).
Settings
The sensitivity of the sensor and other parameters can
be modified using the respective Settings function.
Æ Press the SET button for a few seconds until the acous­
tic signal stops.
Ê
d05 C5 100
and
d05
represents the current value of the memory seg­
C5 100
ment . You can change the value using the ar­
row buttons.
Æ Press the SET button again.
Ê The next memory segment appears together with the
value.
After pressing the SET button for the last memory seg­
ment you exit from Setting function.
G
d
appears in the
appear in the display.