Speaker Connection - Technics SU-R1000 Manuel D'utilisation

Connections
Speakers/AC power supply cord
• Use only the supplied AC power supply cord.
• Insert the plugs of the cables to be connected all the way in.
• Do not bend cables at sharp angles.
• To optimize the audio output, you can measure the amplifier output signal and correct its
output when it is connected to the speakers. ( 22)

Speaker connection

WARNING:
RISK OF HAZARDOUS ENERGY! MAKE
PROPER SPEAKER CONNECTIONS.
CONNECT CABLES AS DESCRIBED IN THIS
OWNER'S MANUAL.
Speaker cable
(not supplied)
1 Turn the knobs to
loosen them, and
insert the core wires
into the holes.
2 Tighten the knobs.
Note
• When the connections are completed, pull the
speaker cables lightly to check that they are
connected firmly.
• Be careful not to cross (short-circuit) or reverse
the polarity of the speaker wires as doing so
may damage the amplifier.
DO NOT
12
(12)
Speakers
• Wire the polarity (+/-) of the terminals correctly.
Not doing so may adversely affect stereo
effects or cause malfunction.
• For details, refer to the operating instructions of
the speakers.
• Though the spade plug (A: 16 mm (
B: 8 mm ( 5 / ") or more) can be connected,
16
some plug may not be connected depending on
the shape of plug.
A B
AC power supply cord connection
Connect only after all other connections are
completed.
AC power supply cord
To a household AC outlet
Insert the AC power supply cord
up to a point just before the
round hole.
Note
• This unit consumes a small amount of AC power
( 28) even when the unit is in standby mode.
Remove the plug from the main electrical outlet
if you will not be using the unit for an extended
period of time. Place the unit so the plug can be
easily removed.
/ ") or less,
5
8
(supplied)