Frequently Asked Questions; Warranty Conditions - Imit Silver CR S Manuel D'instructions

Your Room Thermostat sends the last status signal to the Receiver every 10 minutes.
Thus, your Room Thermostat and Receiver work synchronously. If the signal cannot
reach to the Receiver from the Room Thermostat for 22 minutes, it perceives that the
connection is broken and stops the heating/cooling operation for safety reasons.
Likewise, in cases where the electricity comes back after a power failure, the Receiver
does not operate the heating/cooling unit until 'operate' signal reaches from the Room
Thermostat. However, in this case, if the Room Thermostat continues to operate
normally, it will continue to work properly without any need for intervention since it
sends a status signal to the Receiver every 10 minutes.
WHAT TO KNOW ABOUT TPI ROOM THERMOSTAT
If the placement of the TPI Room Thermostats is changed, the learning process will
restart.
If the TPI Room Thermostats are de-energized (battery replacement), the learning
process will restart. The learning process should be considered as 7 days.

FREQUENTLY ASKED QUESTIONS

• Is my Room Thermostat compatible with my heating/cooling unit?
If your heating/cooling unit has On-Off connections, your Room Thermostat is
compatible. You can find information about your heating/cooling unit from your
heating/cooling unit operating manual or from your heating/cooling unit service.
• How will I connect my heating/cooling unit with my Receiver?
We recommend that the connection between the Receiver and heating/cooling unit
should be made by professionally qualified persons.
2x0.75 mm cable is sufficient for the Receiver – heating/cooling unit connection.
Connect one end of the cable pair to the room thermostat connection terminals stated
in the user manual of your heating/cooling unit.
Connect the other end of the cable pair to COM and NO inputs of the terminal inside the
Receiver as shown in the "RECEIVER WIRING DIAGRAM" section.
The direction of the cable ends does not matter.

WARRANTY CONDITIONS

Refer to the warranty conditions in our catalog or production guide currently in force,
which can be downloaded from the Imit.it website, or request a copy at info@imit.it