Calibration Of The Movement Sensor; Set Up For Use In Attachment Mode - Liemke Merlin-50 Mode D'emploi

16. CALIBRATION OF THE MOVEMENT
SENSOR
The compass and the position
sensors must be calibrated
once for operation. To do this,
please follow the steps below:
> Place the unit on an even
table top.
> Long press the Power button
(6) and the calibration but-
ton (4) simultaneously.
The adjacent symbol is now
displayed.
> Turn the Merlin-50 clockwise 5 times on the table top.
> Put the lens cover on the object. Then place the Merlin-50 on
the lens and also rotate clockwise 5 times.
> Then rotate the Merlin-50 in your hand 5 times around the
battery compartment button (flip it backwards in front of your
stomach).
After approx. 30 seconds the axis icon disappears and the sensor
system is calibrated.
The process can be cancelled by a long press on the menu
button (5).
17. SET UP FOR USE IN ATTACHMENT
MODE
For use as an attachment, you need a suitable clamping adapter,
which is available separately.
Your combination of rifle, day vision optics and night vision attach-
ment must be perfectly matched to each other for expert hunting
use. The final steps can be found in the instructions below:
Preparation:
Adjustment value per 1 click = 1 push of the button
• 50 metres:
• 100 metres:
> The rifle is zeroed with the day vision optics at the operational
distance (usually 100 m).
> Set the scope to the lowest magnification and, if available, set
the parallax compensation of the scope to infinity (∞).
> Screw a suitable clamping adapter onto the connection
thread (2) and pull the counter ring (3) firmly against the
clamping adapter. Make sure that the clamping lever is on the
side or on top.
> Switch on the attachment, place it straight on the optics as far
as it will go and close the clamping lever.
> BEFORE calling up the shift menu, select the memory location
(G1 to G4) that you want to edit in the process. You will not be
able to make a selection later on.
MERLIN-50 · Operating Manual 08 / 2021
1.2 cm height and side adjustment
2.4 cm height and side adjustment
E
N
24
–
25