Polaris GLACIER II Instructions page 3

MOUNT PLATE FOR "GLACIER II" PLOW FRAME
KIT PN 2878824
Application:
Polaris Ranger RZR and RZR-S
Before you begin, read these instructions and check to be sure all parts and tools are accounted for. Please retain these
installation instructions for future reference and parts ordering information.
The contents of this kit include:
Ref. Qty Part Description
. . . . .1 . . . . . .Mount Plate
. . . . .1 . . . . . .Support Plate
. . . . .1 . . . . . .Pull Bar
. . . . .2 . . . . . .Plow Marker Assembly
. . . . .2 . . . . . .Threaded Block
. . . . .4 . . . . . .M10-1.25 X 25 mm Hex Bolt
Tools Required: 13mm and 17mm Open-end Wrench and Socket
IMPORTANT: Your Polaris accessory is exclusively designed for your vehicle. Please read the installation
instructions thoroughly before beginning. Installation of any item is easier if the vehicle is clean and free of debris.
Approximate Installation Time: 45 minutes
NOTE: Winch should be installed prior to mount installation.
INSTALLATION INSTRUCTIONS
1. Remove the roller guide.
2. Fasten the support plate
at this time).
3. If installing an accessory bumper, mount on vehicle at this time.
4. Fasten the front part of the mount plate
lock washers
(2) M10
FRONT VIEW
7515215
A-7515215
and the roller guide to frame of the ATV using
onto the support plate
, and flat washers
(2) M10
Ref. Qty Part Description
. . . . .1 . . . . . .M10-1.5 X 45 mm Hex Bolt
. . . . .2 . . . . . .3/8" nc X 1" Hex Bolt
. . . . .4 . . . . . .M10 Flat Washer
. . . . .4 . . . . . .M10 Lock Washer
. . . . .1 . . . . . .M10-1.5 Nylock Nut
(2) 3/8" nc X 1"
using
(2) M10-1.25 X 25 mm
(finger tighten at this time).
- 1 -
hex bolts (finger tighten
hex bolts
Imprimé en Chine / Printed in China
,