URBANGLIDE M2S Manuel D'utilisation page 13

Your display will show you any malfunctions of your bike. When you see an error code on the
display, turn your bike off, let it sit for 10 minutes, and then turn it on again. If the problem
persists, follow the advice below.
ERROR 07
ERROR 08
ERROR 09
ERROR 11
ERROR 12
ERROR 13
ERROR 14
ERROR 21
ERROR 22
ERROR 30
Error code
Overvoltage protection
Motor problem. Lost signal
Motherboard overheating
Sensor failure
Battery overheating
Motor overheating
Speed sensor failure
Communication problem to
motherboard
General communication problem Let your bike rest. If the error persists,
Let your bike rest. If the error persists,
check the condition of your battery, its
connectors and cables.
Check the condition of the motor
Check the condition of your bike's
Let your bike rest. If the error persists,
check the condition of your bike's
Let your bike rest. If the error persists,
check the condition of your bike's
Let your bike rest. If the error persists,
check the condition of your battery, its
connectors and cables.
Leave your bike to rest. If the error
persists, check the condition of your
motor and cables.
Leave your bike to rest. If the error
persists, check the condition of your
check the condition of your bike's
13
cables.
cables.
cables.
bike's cables.
cables.