Table des Matières
Publicité
Entero
®
Maximum input signal (reduce gain control to avoid saturation)
Input connectors
Output connectors
Fault contact/standby mode connectors
AC Power Supply
Maximum Inrush Current (230 Vac / 50 Hz)
AC Power consumption @ full power (@ minimum load)****
AC Power consumption @ 1/3 & 1/8 power****
AC Idle Power
AC Fuse, size: 5x20
AC Heat Loss (in BTU/h) @ full power, 1/3, 1/8 & Idle
DC Power Supply
DC fuse (blade fuse)
DC Power consumption @ full power****
DC Power consumption @ 1/3 & 1/8 power****
DC Idle Current / Standby Mode
DC Heat Loss (in BTU/h) @ full power, 1/3, 1/8 & Idle
Dimensions (WxHxD) in mm (without rear rack ears)
Operating temperature
Humidity (without condensation)
***NOTE: If external fuses are required; use a 30A fuse for the ESA 8125 and a 60A fuse for the
ESA 8250, between the DC input and the DC power supply.
****NOTE: The power consumption is measured using a slowhoop signal. This slowhoop signal is
the internal emergency alarm tone signal from the Entero
based on a triangle shaped signal; for further details on this signal (4.77 dB crest factor) and battery
capacity calculation see the Entero
power amplifier
Weight
9. Technical Specifications
ESA 8125
18 dBu
3 pin Euro block
4 pin Euro block
2 pin Euro block
230 Vac(-15%/+10%)
50/60 Hz
15A
930 W
340 W / 160 W
64 W
10A, type: T (slow)
2035 / 771 / 394 / 234
48 Vdc (-15%/+10%)
30A (green)***
18A
6.5 A / 3 A
1.4 A / 10 mA
1810 / 640 / 321 / 230
482 x 88 x 463
7.1 Kg
0 to 40 degrees C.
ESC emergency system controller and is
®
ESC emergency system controller manual.
®
ESA 8250
18 dBu
3 pin Euro block
4 pin Euro block
2 pin Euro block
230 Vac(-15%/+10%)
50/60 Hz
23A
1690 W
615 W / 290 W
69 W
16A, type: T (slow)
3493 / 1333 / 689 / 212
48 Vdc (-15%/+10%)
2x 30A (green)***
33A
11.5 A / 5.5 A
1.7 A / 10 mA
3085 / 1094 / 557 / 275
482 x 88 x 463
8.2 Kg
93% max.
13
Publicité
Table des Matières
