Federal Signal 300GC Consignes Pour L'installation Et L'utilisation page 7

nect the line (hot) power source wire to the terminal marked "L". Connect the common
(neutral) power source wire to the terminal marked "N". See Figure 2. If required by
local building codes, connect the earth ground wire to the green screw threaded into the
interior of the housing.
b. 120VAC & 240VAC models
Connect the line (hot) power source wire to the terminal marked "L". Connect
the common (neutral) power source wire to the terminal marked "N". See Figure 2.
If required by local building codes, connect the earth ground wire to the green screw
threaded into the interior of the housing.
Plug the connector into the receptacle provided on the printed circuit board.
2. Tone Card Installation
a. Plug the desired tone card into the socket as shown in Figure 2.
b. To ensure a proper seal, be sure that the rubber cover gasket is properly
seated in the housing groove and reinstall the housing cover.
3. Speaker Connector Card Installation (Models AM25CK, AM70CK, and
300CK).
a. Route the audio signal leads into the enclosure and connect the signal leads
to the connector card audio inputs. The connector cards are NOT polarity
sensitive, however, polarity should be observed when placing units within close
proximity to each other. Refer to the connector card installation manual
provided with the connector card kit for additional wiring information.
b. Plug the desired connector card into the socket as shown in Figure 2.
c. To ensure a proper seal, be sure that the rubber cover gasket is properly
seated in the housing groove and reinstall the housing cover. Tighten the two
screws that secure cover to housing to 25‑30 in‑lbs.
Property damage, serious injury, or death could occur if the housing is not
closed properly. To reduce possibility of explosion, the housing cover must be
kept tight while circuits are energized.
NOTE
Tone card is purchased separately.
NOTE
Connector card is purchased separately.
-6-