Publicité
Les langues disponibles
Les langues disponibles
OPTIONAL ACCESSORIES
Use a pedestal to make
Use the stacking kit to
laundry easier to reach.
mount the dryer on top
White = 796.51022
of the washer to save
Ginger = 796.51028
floor space
Chili Pepper = 796.51029
D26 18992 (Titanium)
Stainless Silver = 796.45009
STACKING KIT INSTALLATION
This stacking kit includes:
• Two (2) side rails
• One (1) front rail
• Four (4) screws
Tools Needed for Installation:
• Phillips-head screwdriver
Make sure the top surface of the washer is clean
and dry. Remove the paper backing from the foam
tape on one of the stacking kit side brackets.
Install each side rail on the side of the washer top
as shown. Firmly press the foam tape in place at
the front. Secure the rear of the bracket with a
screw from the back.
Place the dryer on top of the washer with the feet
slightly forward of the brackets in the side rails as
shown. Slide the dryer back until the rear feet are
held in place by the rear brackets of the stacking
kit. CAUTION: Use care to avoid catching or pinch-
ing fingers while positioning the dryer.
OPTIONAL ACCESSORIES
Use the side vent kit
for venting directly on
either side or on the
bottom.
Kit # D26-49670
• Incorrect installation can cause serious accidents.
• The weight of the dryer and the height of installa-
tion make this stacking procedure too risky for one
person. Two or more people are required when
installing the stacking kit. There is a risk of serious
back injury or other injuries.
• Do not use the stacking kit with a gas dryer in
potentially unstable conditions such as a mobile
home. Failure to follow this warning can result in seri-
ous injury.
• Place the washer on a solid, stable, level floor
capable of supporting the weight of both appli
ances. Failure to follow this warning can result in seri-
ous injury.
• Do NOT stack the washer on top of the dryer.
Failure to follow this warning can result in serious
injury.
• If appliances are already installed, disconnect them
from all power, water, or gas lines and from drain-
ing or venting connections. Failure to do so can
result in electrical shock, fire, explosion, or death.
Dryer
Washer
Insert the cross rail between the washer and dryer
with the tabs on top. Push the rail back until the
tabs are on top of the feet and the screw holes line
up. Install one screw on each end of the rail to lock
it and the dryer in place.
32
Use the LP CONVERSION
KIT for changing the dryer
Remote Laundry Monitor
gas connections from
Check the status of a load
Natural Gas (NG) to
of laundry from anywhere in
Liquefied Propane Gas (LP)
the house without special
4948EL4002C
wiring. This unit plugs into
NOTE: Installation of the LP
any standard household
conversion kit must be
outlet and toggles between
performed by a qualified
washer and dryer status.
service professional.
WARNING:
Publicité
