TechniSat DIGITRADIO 50 SE Notice D'utilisation page 96

10.6 Factory settings
If you change the location of the device, e.g. when moving house, it is possible that the
saved stations may no longer be received. In this case you can reset the device to factory
settings to delete all the saved stations and then launch a new scan.
> Open Menu > [Factory settings]
> To perform the factory settings, turn Tune/Select (4) to select [Yes] and press
Tune/Select (4) to confirm.
All previously stored stations and settings will now be deleted. The device is now in
the same status as when delivered.
The display will show [Restart ...] and the device will then start in standby mode.
10.7 Software version
> Open Menu > [SW version] to display the software version on the radio.
96
BDA_DIGITRADIO 50 SE_V1aSA.indd 96 BDA_DIGITRADIO 50 SE_V1aSA.indd 96 30/09/2022 16:02 30/09/2022 16:02