AQUAJOE AJ-SPXN Instructions page 3

Fig. 2
Operation
Starting + Stopping
1. With the water supply turned on and the
nozzle pointed to the car, squeeze the trigger.
To keep the water flowing without squeezing,
engage the trigger lock (Fig. 3).
Fig. 3
Trigger lock
Squeeze the
trigger
2. To stop, disengage the trigger lock and
release the trigger.
Adjusting Water Flow and
Spray Angle
1. During operation, use the water flow throttle to
adjust the water flow (Fig. 4).
Fig. 4
Increase
NOTE: The water flow rate can be adjusted
from as low as 2.8 GPM to as high as 3.3
GPM. Generally, with a higher water flow rate
there will be more water released from the
trigger gun. If the foam cannon is used, the
detergent in the bottle will be used up sooner
with a higher water flow setting.
2. When using the spray nozzle tip, the spray
can be adjusted from 0° pencil spray to 65°
fan spray as needed by turning the nozzle tip
(Fig. 5).
Garden hose
connection
Garden hose
Decrease
Water flow Throttle
Fig. 5
0° Pencil Spray
Working with Foam Cannon
For additional cleaning power, the unit comes
equipped with a foam cannon spray bottle.
1. Remove the foam cannon cap with detergent
suction tube from the detergent bottle. Fill the
detergent bottle with proper detergent mixed
with water as instructed on the detergent
label/manual (Fig. 6).
Fig. 6
Foam cannon
cap with
suction tube
Detergent bottle
2. With the trigger released and the water supply
shut off, disconnect the spray nozzle by
pulling back the Quick-Connect collar (Fig. 7).
Fig. 7
Spray nozzle
Quick-Connect
collar
NOTE: Do not make change to nozzles when
the sprayer is on.
3. Snap the foam cannon onto the Quick-
Connect collar until it clicks into place (Fig. 8).
3
65° Fan Spray