Ac Voltage Measurement; Dc Or Ac Current Measurement; Function Generator - Parkside PDM 300 C2 Mode D'emploi

PARKSIDE PDM 300 C2
• The measured reading is now shown on the display [1]. If the measured reading is negative, a minus
sign is shown in front. If "OL" is flashing on the display [1], AC voltage is being measured. Set the
range selector switch [3] to the V

7.3 AC voltage measurement

• Connect the black measurement cable to the COM connection [4] and the red measurement cable
to the OUT INPUT connection [5].
• Set the range selector switch [3] to the V
• Connect the measurement probes [6] to the object to be measured.
• The measured reading is now shown on the display [1].

7.4 DC or AC current measurement

• Connect the black measurement cable to the COM connection [4] and the red measurement cable
to the 10 A connection [7] (for currents > 200 mA) or the
currents < 200 mA).
• Select the range selector switch [3] to the current measurement range you want (μA, mA or A).
If you do not know the current level, set it first to the highest measurement range and then switch
down to the lower ranges until you have a satisfactory reading.
• Press the SELECT button [8] to switch between direct and alternating current. The relevant symbol is
shown on the display [1].
• Connect the measurement probes [6] in series to the object to be measured.
• The measured reading is now shown on the display [1]. If the measured reading is negative, a minus
sign is shown in front for DC current measurements.

7.5 Function generator

CAUTION! Make sure that all circuit components, circuits and parts to be measured are
disconnected and discharged. Otherwise the multimeter could get damaged.
• Connect the black measurement cable to the COM connection [4] and the red measurement cable
to the OUT INPUT connection [5].
• Set the range selector switch [3] to the
• Connect the measurement probes [6] to the object to be measured.
The 1 kHz square wave signal is used, among other things, for checking and repairs on
headphones, amplifiers and other electronic devices and components.
10 - English
position.
~
position.
~
position.
OUT INPUT connection [5] (for