Unpack The Beverage Cooler; Install The Casters - Gladiator GABC05FDKG Guide D'utilisation Et D'entretien

Unpack the Beverage Cooler

WARNING
Excessive Weight Hazard
Use two or more people to move and install
beverage center.
Failure to do so can result in back or other injury.
Remove the Packaging
Remove tape and glue residue from surfaces before turning on
■
the beverage cooler. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water and
dry.
Do not use sharp instruments, rubbing alcohol, flammable
■
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your beverage cooler.
For more information see "Beverage Cooler Safety."
Dispose of/recycle all packaging materials.
■
1.
Install the Front Casters
Philips-head Screw
For caster attachment, using two or more people, lower the
Beverage Cooler on its back. The front casters are fixed and have
a brake on the side. The brake should face to the outside of the
Beverage Cooler. To attach the fixed casters to the front location,
align the holes on the casters with the holes and tabs on the front
mounting plate as shown. Attach each fixed caster with 2 Philips-
head screws (F1).

Install the Casters

F1
When Moving Your Beverage Cooler:
Your Beverage Cooler is heavy. When moving the Beverage
Cooler for installation, cleaning, or service, be sure to cover
the oor with cardboard or hardboard to avoid oor damage.
Always pull the Beverage Cooler straight out when moving it.
Do not wiggle or "walk" the Beverage Cooler when trying to
move it, as oor damage could occur.
Clean Before Using
After you remove all of the package materials, clean the inside of
your beverage cooler before using it. See the cleaning instructions
in "Beverage Cooler Care."
Important information to know about glass shelves and
covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
2.
Install the Rear Casters
Philips-head Screw
The rear casters swivel to allow for ease of mobility of the
Beverage Cooler. To attach the rear swivel casters to the rear
location, align the holes on the casters with the holes and tabs on
the rear mounting plate as shown. Attach each swivel caster with
2 Philips-head screws (F1). Return the Beverage Cooler to the
upright position.
F1
5