Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Location Requirements
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion, or fire.
To ensure proper ventilation for your beverage cooler, allow for a
1/4" (6.35 mm) space on each side and at the top. When installing
your beverage cooler next to a fixed wall, leave 2½" (6.35 cm)
minimum clearance on the hinge side to allow for the door to
swing open.
NOTE: It is recommended that you do not install the beverage
cooler near an oven, radiator, or other heat source. Do not install
in a location where the temperature will fall below 0°F (-17°C)
or above 110°F (43°C). For best performance, do not install the
beverage cooler behind a cabinet door or block the base grille.
1" (25.4 mm)
NOTE: Make sure to locate your beverage cooler in a location
that does not allow vehicle doors, or any other object, to contact
the glass door.
4
INSTALLATION INSTRUCTIONS
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your beverage cooler into its final location, it is
important to make sure you have the proper electrical connection.
Recommended Grounding Method
A 115 V, 60 Hz, AC only, 15 or 20 A fused, grounded electrical
supply is required. It is recommended that a separate circuit
serving only your Beverage Cooler be provided. Use an outlet that
cannot be turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation or cleaning,
disconnect the beverage cooler from the electrical source. When
you have finished, reconnect the beverage cooler to the electrical
source.
Publicité
Table des Matières
Dépannage
