Vacation And Moving Care; Troubleshooting - Gladiator GABC05FDKG Guide D'utilisation Et D'entretien

Vacations
If you choose to turn the beverage cooler off before you leave,
follow these steps.
1. Remove all beverages from the beverage cooler.
2. Unplug the beverage cooler.
3. Clean the beverage cooler. See "Cleaning."
4. Tape a rubber or wood block to the top of the door to prop it
open far enough for air to get in. This stops odor and mold
from building up.
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
If you experience
Your beverage cooler will not
operate
The lights do not work
The motor seems to run too
much
10

Vacation and Moving Care

TROUBLESHOOTING

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Possible Causes
Is the power supply cord unplugged? Plug into a grounded 3 prong outlet.
Has a household fuse blown, or has
a circuit breaker tripped?
Is the Beverage Cooler Control
turned to the OFF position?
Is the power supply cord unplugged?
Are the lights turned off?
Is the temperature outside hotter
than normal?
Is the door opened often?
Moving
When you are moving your beverage cooler to a new home,
follow these steps to prepare it for the move.
1. Remove all beverages from the beverage cooler.
2. Unplug the beverage cooler.
3. Clean the beverage cooler. See "Cleaning."
4. Take out all removable parts, wrap them well, and tape them
together so they don't shift and rattle during the move.
5. Tape the doors shut and tape the power cord to the beverage
cooler.
When you get to your new home, put everything back and refer to
the "Installation Instructions" section for preparation instructions.
Replace the fuse or reset the circuit breaker.
See "Operating Your Beverage Cooler."
Plug into a grounded 3 prong outlet.
See "Lighting the Beverage Cooler" section in this manual.
Your Beverage Center is equipped with an LED light strip
which does not need to be replaced. If there is power to
the beverage center, and the lights are turned on but they
do not light, call for service or assistance.
Expect the motor to run longer under warm conditions. At
normal temperatures, expect your motor to run about 40%
to 80% of the time. Under warmer conditions, expect it to
run even more.
Expect the motor to run longer when this occurs. In order
to conserve energy, try to get everything you need out of
the beverage cooler at once, keep wine bottles positioned
label side up so that they are easy to find, and close the
door as soon as the wine is removed.
Solution