Operational Safety - Beko B1RCNA344W Manuel D'utilisation

Safety instructions
• Do not connect the product to supply
systems such as solar power supplies.
Otherwise, damage to your product
may occur as a result of the abrupt
voltage fluctuations!
• The more refrigerant a refrigerator
contains, the bigger its installation
room shall be. In very small rooms,
a flammable gas-air mixture may
occur in case of a gas leak in the
cooling system. At least 1 m3 of
volume is required for each 8 grams
of refrigerant. The amount of the
refrigerant available in your product
is specified in the Type Label.
• The installation place of the product
shall not be exposed to direct
sunlight and it shall not be in the
vicinity of a heat source such as
stoves, radiators, etc.
If you cannot prevent installation of the
product in the vicinity of a heat source,
you shall use a suitable insulation plate
and the minimum distance to the heat
source shall be as specified below.
- At least 30 cm away from heat so-
urces such as stoves, heating units and
heaters, etc.,
- And at least 5 cm away from electric
ovens.
• Your product has the protection
class of I. Plug the product in a
grounded socket that conforms with
the Voltage, Current and Frequency
values specified in the type label. The
socket outlet shall be equipped with a
fuse with a rating of 10 A – 16 A. Our
company shall not be responsible for
the damages that shall be incurred
as a result of operating the product
without ensuring ground and
electrical connections made as per
local or national regulations.
Refrigerator/User Manual
• The product's power cable must
be unplugged during installation.
Otherwise, risk of electric shock and
injury may occur!
• Do not plug the product to loose, bro-
ken, dirty, greasy sockets or sockets
that has come out their seats or soc-
kets with a risk of water contact.
• Place the power cord and hoses (if
available) of the product so that they
shall not cause a risk of tripping over.
• Penetration of humidity to live parts
or to the power cord may cause short
circuit. Thus, do not use the product
in humid environments or in areas
where water may splash (e.g. garage,
laundry room, etc.) If the refrigerator
is wet by water, unplug it and contact
an authorized service.
• Do not connect your refrigerator to
power saving devices. These systems
are harmful for the product.

1.6 Operational safety

• Do not use chemical solvents on the
product. These materials contain an
explosion risk.
• In case of a failure of the product,
unplug it and do not operate until it
is repaired by the authorized service.
There is a risk of electric shock!
• Do not place a source of flame (e.g.
candles, cigarettes, etc.) on the pro-
duct or in the vicinity of it.
• Do not get on the product. Risk of fal-
ling and injury!
• Do not cause damage to the pipes of
the cooling system using sharp and
piercing tools. The refrigerant that
sprays out in case of puncturing the
gas pipes, pipe extensions or upper
surface coatings may cause irritation
of skin and injuries of the eyes.
• Do not place and operate electric app-
liances inside the refrigerators/deep
freezer unless it is advised by the ma-
nufacturer.
5 / 23 EN