Appropriate Installation Location - Beko B1RCNA344W Manuel D'utilisation

4 Installation
Read the "Safety Instructions" section
first!
4.1.Appropriate
Installation Location
Contact an Authorized Service for the
installation of the product. In order to
prepare the product for use, refer the
information in the user manual and
ensure that electrical installation and
water installation are appropriate. If not,
call a qualified electrician and technician
to have any necessary arrangements
carried out.
WARNING: Manufacturer
shall not be held liable for
B
damages that may arise from
procedures carried out by
unauthorized persons.
WARNING: Product must
not be plugged in during
B
installation. Otherwise, there
is the risk of death or serious
injury!
WARNING:
If the door clearance of the
room where the product shall
be place is so tight to prevent
passing of the product, remove
A
the door of the room and pass
the product through the door
by turning it to its side; if this
does not work, contact the
authorized service.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least 30 cm away
from heat sources such as hobs, heater
cores and stoves and at least 5 cm
away from electrical ovens.
• Product must not be subjected to
direct sun light and kept in humid
places.
• Appropriate air ventilation must be
provided around your product in order
to achieve an efficient operation. If the
product is to be placed in a recess in
the wall, pay attention to leave at least
5 cm distance with the ceiling and side
walls.
• Please provide at least 5cm distance
for air circulation between the back
side of your product and the wall to
avoid condensation on the rear panel
of product.
• Your product requires adequate air
circulation to function efficiently.
If the product will be placed in an
alcove, remember to leave at least 5
cm clearance between the product
and the ceiling, rear wall and the side
walls.
• If the product will be placed in an
alcove, remember to leave at least 5
cm clearance between the product
and the ceiling, rear wall and the
side walls. Check if the rear wall
clearance protection component is
present at its location (if provided
with the product). If the component
is not available, or if it is lost or fallen,
position the product so that at least
5 cm clearance shall be left between
the rear surface of the product and
the wall of the room. The clearance
at the rear is important for efficient
operation of the product.
10 / 23 EN
Refrigerator/User Manual