American Standard EDGEMERE 7018.201 Serie Instructions D'installation page 2

3
POP-UP DRAIN
• Remove CLEAR PLASTIC COVER (1).
• Remove CARDBOARD SPACER (2) from under
DRAIN POP-UP (3).
• Tighten TAILPIECE (4) on DRAIN BODY before
installing DRAIN BODY. Fig. B.
4
REMOVE FLANGE
• Thread FLANGE (1) counter-clockwise and
remove FLANGE (1) and FOAM GASKET (2)
from drain body. Fig. A.
• Thread LOCKNUT (3) clock-wise to bottom of
drain body. Push GASKET (4) down against
LOCKNUT (3). Fig. B
5
INSTALL DRAIN FROM
BELOW FIXTURE
• From under side of SINK install
DRAIN BODY (1) up through
drain outlet.
• Note: No plumber's putty
or caulk is required.
The CABLE ATTACHMENT
POINT (2) must face towards
the rear of the SINK.
• Install FOAM GASKET (3) and
FLANGE (4) onto drain body
from above SINK and tighten
FLANGE (4) firmly.
6
FLANGE GASKET AND POP-UP KNOB
• Check DRAIN FLANGE in SINK to ensure that
WHITE FOAM GASKET (3) is fully compressed
and not visible. Fig. A.
• POP-UP KNOB (1) must be fully down. Fig. B.
Fig. A.
1
3
2
Fig. A.
1
4
DRAIN
OUTLET
3
Fig. A.
WHITE FOAM
GASKET
NOT VISIBLE
- 2 -
Fig. B.
Fig. B.
4
2
3
5
TIGHTEN LOCKNUT
REAR
OF
• Tighten LOCKNUT (1) firmly with
SINK
Adjustable Wrench or Channel Locks.
1
2
Fig. B.
DRAIN
FLANGE
DRAIN
BODY
4
1
DOWN
1
M965805 1.0 (4/22)