American Standard EDGEMERE 7018.201 Serie Instructions D'installation page 6

STOPPER INSTALLATION PROCEDURE
The Stopper can be installed two ways, "Locked" Mode (Stopper cannot be
Removed) or "Unlock" Mode (Stopper is removable).
Locked Mode:
• Look at the Plastic Loop at the bottom of the Stopper and notice that the
Loop is on one side of the Stopper. Fig. G.
• To install the stopper in "Locked" mode, insert the Stopper into the Drain so
that the Plastic Loop is facing toward the rear of the Sink and the American
Standard logo is facing front. Rotate Stopper slightly if necessary so that the
Stopper slides all the way down. Fig. G.
• Re-install the Cam into the Drain, rotating the Cam if necessary to make sure
it is fully inserted. Fig. J.
• Re-install the Cam Cap, making sure the guide teeth are facing outward. If
the Cam Cap does not "snap" into place, then rotate the Cam to make sure
it is fully inserted. Fig. K.
• Re-attach Cable. See "CABLE ADJUSTMENT PROCEDURE" in Troubling
Shooting Guide to complete installation. Stopper will be in "Locked" mode
and not be removable.
Unlocked Mode:
• Look at the Plastic Loop at the bottom of the Stopper and notice that the
Loop is on one side of the Stopper. Fig. H.
• To install the stopper in "Unlocked" mode, insert the Stopper into the Drain
so that the Plastic Loop is facing toward the front of the Sink and the American
Standard logo is facing rear. Rotate Stopper slightly if necessary so that the
Stopper slides all the way down. Fig. H.
• Re-install the Cam into the Drain, rotating the Cam if necessary to make sure it
is fully inserted. Fig. J.
• Re-install the Cam Cap, making sure the guide teeth are facing outward. If the
Cam Cap does not "snap" into place, then rotate the Cam to make sure it is
fully inserted. Fig. K.
• Re-attach Cable. See "CABLE ADJUSTMENT PROCEDURE" in
"Troubleshooting Guide" to complete installation. Stopper will be in
"Unlocked" mode and removable.
Fig. J.
INSTALL CAM
- 6 -
LOGO
LOOP TOWARD
REAR OF SINK
DRAIN
Locked Mode
(Vandal Proof)
LOGO
180˚
LOOP TOWARD
FRONT OF SINK
DRAIN
Unlocked Mode
Fig. K.
CAM
INSTALL
CAM CAP
M965805 1.0 (4/22)
Fig. G.
Fig. H.