Table des Matières
Publicité
Identification data
The plate under the appliance base
reports the following identification
data of the appliance:
• manufacturer and CE marking
• model (Mod.)
• electrical supply voltage (V) and
frequency (Hz)
• electrical power consumption (W)
• assistance toll-free phone number
When contacting the Authorized
Service Centres, please report the
model and serial number of the
appliance.
Description of the
appliance
Water tank filling lid
Steam adjustment selector
Power cord protection
Iron rest
Iron temperature indicator light
Tank (130 ml)
Soleplate
• This iron is provided with the Ideal
Temp technology which allows to
iron every kind of fabric without
the need to adjust steam or the
soleplate temperature.
Instructions for use
1 Set the steam adjustment selector
to the symbol (
2 Hold the iron tilted and fill the tank
with fresh tap water up to the
maximum level. If your water supply
is very limestone, use demineralized
water.
•
Do not pour vinegar,
descaling products or other
scented substances into
the tank. Otherwise, the
warranty may be revoked.
Important
• When using the iron for the first time,
you may notice a delay in steam
formation. This is normal and is due to
water starting to circulate into the iron.
• When used for the first time, the
appliance may give out a little
smoke. This transitory effect is
English
).
perfectly normal and is due to the
fact that some components have
been slightly lubricated.
3 Place the iron upright on the iron rest
.
4 Totally unwind the power cord.
5 Plug the power cord into the mains
socket.
• The iron temperature indicator light
starts flashing. When the iron
temperature indicator light
off, the iron is ready to use.
6 If you need to add water while
ironing, always turn off the appliance
and unplug the power cord from the
mains socket before filling the tank
with water.
Steam ironing
• Make sure there is enough water in
the tank.
1 Place the iron upright on the iron rest
.
2 Plug the power cord into the mains
socket.
3 Turn the steam adjustment selector
clockwise and set the steam
level to the symbol (
• When the iron temperature indicator
light
turns off, the iron is ready to
use.
• To get maximum steam supply, set
the selector to the symbol (
• When setting the selector to the
symbol (
Dry ironing
1 Plug the power cord into the mains
socket.
2 Turn the steam adjustment selector
counterclockwise and set the
steam level to the symbol (
• When the iron temperature indicator
light
turns off, the iron is ready to
use.
After ironing
1 Turn the steam adjustment selector
counterclockwise and set the
steam level to the symbol (
2 Unplug the appliance from the mains
socket.
11
).
) steam is not supplied.
turns
).
).
).
Publicité
Table des Matières
