Tripp-Lite PDUB15 Guide De L'utilisateur page 3

Mounting
(continued)
Step 2. Install 4POSTRAILKIT into the rack using only the top mounting hole
side of the rear of the 4POSTRAILKIT mounting shelves. (The screws at the front
of the shelves will not change from the standard procedure shown in your UPS or
4POSTRAILKIT manual.)
Step 3. Install the PDU into the rack using the bottom two mounting holes
the rear of the 4POSTRAILKIT mounting shelves.
Warning! Refer to the diagrams below to make sure the UPS system's airflow is
not obstructed. If the UPS system's airflow is obstructed, the UPS system will
overheat.
A
at each
Step 2
B
at each side of
Step 3
3
A
B
12A MAX.
26
OUTPUT
25
12A MAX.
A
B