Napoleon PTH55NSS-1 Manuel D'installation Et D'opération page 17

STEP 6:
6-1 Place 3 reflector washers (H)
on top of burner then place
reflector on top of burner.
6-2 Place 3 pcs of wing nuts (H)
on top of the supporting bolts
and tighten them.
WARNING NOTE: This model is not equipped with
an anti-tilt switch. Must be secured into
STEP 7:
7-1 Bolt 3 bolts down to the floor to secure
heater into place through the opening
on the L-shaped stabilizer as shown.
7-2 3 bolts for wooden (J) are provided,
but the 3 bolts for soil surfaces
are not included into the package.
Should be the heater needs to be
placed on other surfaces, please
purchase the different types of bolts
accordingly from your local hardware
store.
position.
STEP 8:
8-1 Setup is now complete. Please
check and make sure that
the center post and the burner
assembly stand vertically as shown.
8-2 Make sure all bolts and nut pairs
are tightened.
8-3 Ensure correct connection by local
gas professional.
17