TOOLS NEEDED (NOT SUPPLIED)
•
10mm Open Ended Wrench
•
13mm Open Ended Wrench
2 x 8 "Adjustable Wrenches
•
•
Slip joint pliers 9 inches long
•
Philips Screwdriver Medium Blades
•
eflon Plumbing Tape for Joints
•
Spray Bottle Filled with Soapy Water to Check for Leaks
PARTS CHECK LIST:
ATTENTION:
IT'S STRONGLY RECOMMENDED TO SECURE THE BASE BY SCREWING BOLTS
ON ANY GROUND SURFACE THE HEATER STANDS.
STEP 1:
1.1 Using screws(L), place L-shaped stabilizers
(I) to bottom base(B).
ASSEMBLY PROCEDURE
15
STEP 2:
2-1 Place base post (G) on
the bottom base(B) upward.
2-2 Secure using screws(L).