Beem 05015 Mode D'emploi page 34

EN
Preparing Milk Froth
1. Fill the water tank (h) (see the "Handling and Operation" chapter – "Filling the Water Tank").
2. Switch on the device by touching the fi eld
fl ash. The device starts the heating process. As soon as all operating fi elds are permanently
lit, the device is preheated.
3. Touch the fi eld
up to a higher temperature.
4. Direct the steam nozzle (6) towards the drip tray (e) or into an empty vessel.
5. Start the steam process as soon as the fi eld
steam power control (1) to the
existing condensation is drained away.
6. Turn the selector switch to the
steam nozzle.
7. Pour milk at fridge temperature with a fat content of at least 2% to a level of roughly two-
thirds in a container with a handle for frothing.
Please Note! The container must be large enough as the milk will expand when it froths up.
8. Direct the steam nozzle into the frothing container and immerse it in the milk.
9. Start the frothing process by gradually turning the steam power control to the
position.
10. First hold the steam nozzle just below the surface of the milk to warm it up. Once the milk
is warm to the touch, hold the steam nozzle at the bottom of the frothing container so that
the milk is swirled around.
11. Once the milk froth is of the desired consistency, turn the selector switch to the
and pull the frothing container down and outwards.
12. Tap the frothing container one to two times on a solid surface to compress the milk froth.
13. Pour the milk froth into the drinking vessel or scoop it with a spoon.
14. Clean the steam nozzle after each use to prevent a blockage (see the "Cleaning and Care"
chapter – "Cleaning the Steam Nozzle").
Empty the drip tray after preparation so that it does not overfl ow if you prepare another
drink.
15. When you want to exit steam mode, press the fi eld
again.
16. If you no longer wish to use the device, touch the fi eld
device switches to stand-by mode.
If the device is not switched off manually, after 25 minutes it automatically switches to
stand-by mode.
05015_DE-EN-FR-ES-IT_Inlay_A5_V2.1.indb 34 05015_DE-EN-FR-ES-IT_Inlay_A5_V2.1.indb 34
(3) to switch to steam mode. The fi eld
position. The device starts to emit steam, and any
position as soon as steam emerges continuously from the
(4). The other operating fi elds light up and
fl ashes and the device heats
is constantly lit by gradually turning the
again. All operating fi elds light up
for approx. 3 seconds. The
34
position
29.01.2021 15:11:06 29.01.2021 15:11:06