Storage And Transport - JSP FAR0701 Instructions Pour L'utilisation, L'entretien Et L'inspection

• If the risk assessment carried out before the start of the work shows that the edge is very "cutting" and / or "free of
burrs" (such as in case of an unclad roof parapet, a rusty steel girder or a concrete edge), relevant measures shall be
taken before the start of the work to prevent a drop over the edge or, before the start of work, an edge protection shall
be mounted or the manufacturer shall be contacted.
• The anchor point should only be situated at the same height as the edge at which a fall might occur or above the edge.
• Allow adequate clearance of minimum 4.5 meters below, in order to avoid collision with the adjacent structures or the
ground in the event of a fall. With a mass of 100 kg, the clearance is the arrest distance H plus an extra distance of 1m.
• To attenuate a drop ending in a pendulum movement, the working area or lateral movements to both sides of the
centre axis shall be limited to a maximum of 1.50m. In other cases, no individual anchor points, but, e.g., type C or
type D anchor devices in accordance with EN 795 shall be used.
• The Self Retracting Lifeline can also be used with Type C anchor device.
• The deflection of the anchor device shall be taken into account when determining the clearance required below the feet
of the user. To that effect, the indications specified in the instructions for use of the anchor device shall be considered.
• Care must be taken to avoid collision with any obstruction in the event of a fall.
• It is advised that, for the event of a fall over the edge, special pre-planned rescue measures must be taken under the
guidance of a well-trained and competent personnel.
• For the Self retractable lifelines with a shock absorber, the length of the shock absorber deployed is 115 cm.
MATERIAL
JSP reference Material of the retractable lanyard
FAR0701 Polyester webbing 21 mm
FAR0705 galvanised steel wire rope 4.5 mm
FAR0706 galvanised steel wire rope 4.5 mm
FAR0707 galvanised steel wire rope 4.5 mm
FAR0712 galvanised steel wire rope 4.5 mm
FAR0720 galvanised steel wire rope 4.8 mm
FAR0721 galvanised steel wire rope 4.8 mm
FAR0730 galvanised steel wire rope 4.5 mm
FAR0731 Polyester webbing 21 mm
Length
2 m
5 m
10 m
15 m
20 m
5 m
10 m
20 m
2 m
6
COMPATIBILITY
Conforming to the EN 363, the fall arrest system must use:
• Connectors conforming to EN 362 for connecting to the anchor points and to the harness.
• An anchor point conforming to EN 795.
• A harness conforming to EN361.
The instructions for use for the individual components are to be observed. Also ensure that the harness has an
attachment point located appropriately in relation to the SRL.
LIFETIME
The maximum life span of the product is 10 years from the date of manufacture. The life span greatly depends upon the
conditions of usage of the product. Products must be inspected at least once a year by a trained and competent person.
If in any doubts, please contact JSP Safety.

STORAGE AND TRANSPORT

The Personal Protective Equipment must be transported in a package that protects against moisture, mechanical,
chemical and thermal attack. Store in a cool dry place. Avoid humid & acidic environment for storage.
MAINTENANCE
In case of minor soiling, wipe the equipment with a cotton cloth or soft brush. Do not use any abrasive material. For
intensive cleaning wash in water at a temperature between 25°C to 50°C using a neutral detergent. It should be allowed
to dry by itself and be kept away from open fires/flames or any other source of heat. Avoid direct sunlight.
7