Plebani Fly'n Board Instructions D'assemblage Et D'emploi page 17

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

COMPONENTS:
In addition to this instruction manual, inside packing you will find the following components
for assembling and fixing the board to stroller:
A - Board
B - Fixing Connectors (Left & Right)
C - Arms (Left & Right)
D - Wheels
E - Washers
F - Carrying Strap
BOARD ASSEMBLING:
Turn board face down (with the logo facing down), insert the washer on the wheel hub
(unless it is already inside wheel's housing) and insert everything into hole, pushing well to
bottom (CLICLK) (Fig. 1). Make the same operations for the other wheel. Take a connector,
press the release button and slip strap off (Fig. 2) right to the end. Make sure it's
completely out and free (Fig. 3).
Get a connector closer to stroller's tube and insert strap into slot (Fig. 4).
IMPORTANT!: For correct assembling of connectors on tubes of stroller/pram, release
slider must be upwards (Fig. 5).
Pull strap well until connector is fully fitted to frame (Fig. 6). Let it fit to tube screwing
(clockwise) slightly the knob (Fig. 7).
Do the same operation for the other connector. Make sure that both connectors are at the
same height from the ground!
Unscrew knobs under board (Fig. 8) and insert the two arms in their side seats (Fig. 9). To
determine arms inclination angle (Fig. 10), put boar with wheels on ground and close to the
hooks, so that it is parallel to ground (Fig. 11).
Then adjust arms width depending on the distance of the wheels (Fig. 12) maintaining
board at same distance from both arms.
You can closer to or farther the board from stroller (Fig. 13) by pressing release button of
slider and then adjusting its position, more or less close to the stroller (Fig. 14).
Once made all adjustments, lock arms screwing knob under board (Fig. 15) on both sides,
fix board to connectors (Fig. 16) checking that the locking tab on the connector is properly
out (CLICK) (Fig. 17).
Now your "FLY'N BOARD" is ready for use (Fig. 18). Check that all the parts are well fixed
and properly assembled.
1 Pc
2 Pcs
2 Pcs
2 Pcs
2 Pcs
1 Pcs
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

220

Table des Matières