Beem 02275 Mode D'emploi page 18

EN
Do not make any modifications to the device. Do not replace the
•
connecting cable yourself. If the device or the connecting cable are
damaged, they must be replaced or repaired by the manufacturer,
customer service department or authorised distributors in order to
avoid any hazards.
It is essential to follow the instructions in the "Cleaning and Care"
•
chapter.
DANGER – Danger of Electric Shock
• Use the device only in closed rooms.
• Do not use the device in rooms with high humidity.
• If the device falls into water while it is connected to the mains power, switch off the power
supply immediately! Only after this should you pull the device out of the water.
• Never touch the device and the connecting cable with wet hands when the device is connect-
ed to the mains power.
• Make sure that the steam which emerges does not come into contact with electrical devices
and equipment containing electrical components.
WARNING – Danger of Injury
• Keep the packaging material away from children and animals. There is a danger of suffocation!
Danger of scalding from heat, hot steam or condensation!
• Avoid coming into contact with the rising steam. Do not open the lid of the device during
the brewing process.
• Do not move the device during the brewing process.
• Be careful when removing the filter insert or permanent filter after operating the device.
There may still be hot water remaining in / on the filter insert or permanent filter! Always
allow the filter insert and the permanent filter to cool down first before they are removed
/ cleaned.
• Make sure that the connecting cable does not present a trip hazard. The connecting cable
should not hang down from the surface on which the device is placed in order to prevent the
device from being pulled down.
• Make sure that the connecting cable is kept out of the reach of small children and animals.
There is a danger of strangulation!
18