Get Started; Power Off - defunc TRUE GO SLIM Mode D'emploi

GENERAL TIPS FOR TRUE WIRELESS EARBUDS
• Because of interference with other Bluetooth devices, the earbuds
can get disconnected from each other. If you experience this
problem, place the earbuds in the charging case and close the cap.
After a few seconds, open the cap and start using the earbuds again.
• Hold the earbud stem when putting or adjusting the earbuds in
your ears. This way you avoid touching the sensitive touch area which
control different functions.
• The volume effects the capacity of the battery. If you play your music
with lower volume, you will increase battery life.

GET STARTED

1. Make sure the earbuds are fully charged. Do this by charging the
charging case with the earbuds in until the 4 green lights on the
charging case are lit.
2. Open the charging case, take out the earbuds. The earbuds will
automatically power on and pair with each other.
3. When blue and red lights on either earbud flashes alternately,
the earbuds are ready to pair with your device.
4. Turn on the Bluetooth function on your device and select
Defunc TRUE GO SLIM in the list to pair earbuds with the device.
POWER ON
There are two ways to turn the earbuds on:
1. Remove the earbuds from the charging case for auto-power on.
2. Press the touch area for 3 seconds.

POWER OFF

There are three ways to turn the earbuds off:
1. Put the earbuds back in the charging case and close the cap.
2. Press the touch area for 5 seconds.
3. The earbuds turn off after 5 minutes if not active. 5