Formlabs BioMed Clear Resin Instructions page 3

3. Hazards And Precautions
HAZARDS
BioMed Clear Resin (uncured) contains polymerizable monomers which may cause
skin irritation (allergic contact dermatitis) or other allergic reactions in susceptible
persons. If resin contacts skin, wash thoroughly with soap and water. If skin
sensitization occurs, discontinue use. If dermatitis or other symptoms persist,
seek medical assistance.
1. Eye contact: High vapor concentration may cause irritation.
2. Skin contact: May cause sensitization by skin contact. Irritating to skin.
Repeated and/or prolonged contact may cause dermatitis.
3. Inhalation: Irritating to the respiratory system. Prolonged or repeated exposure
may cause: headache, drowsiness, nausea, weakness (severity of effects
depends on the extent of exposure).
4. Ingestion: Low oral toxicity, but ingestion may cause irritation of the
gastrointestinal tract.
5. Protection: Protective glasses and nitrile gloves should be worn while handling
BioMed Clear. Detailed information about the handling of BioMed Clear can be
found in the Safety Data Sheets at support.formlabs.com.
PRECAUTIONS
1. When washing the printed part with solvent, it should be in a properly
ventilated environment with proper protective masks and gloves.
2. Expired or unused BioMed Clear shall be disposed in accordance with
local regulations.
3. IPA shall be disposed of in accordance with local regulations
4. Manufacturing Procedure With BioMed Clear Resin
A. PRINTING AND POST-PROCESSING
1. Shake cartridge: Prior to use, shake cartridge well. Color deviations and print
failures may occur if the cartridge is shaken insufficiently.
2. Set up: Insert resin cartridge into a compatible Formlabs 3D printer.