Maintenance; How To Clean Your Ceiling Fan Blades - Fanimation ZONIX WET FP4640B Serie Manuel D'instructions

Mounting the Fan Blades and Switch Cup Cover Assembly
(Continued)
3.
Remove one of the three screws in the support
bracket. Attach the switch cup support cover to the
support flange by rotating plate and properly
positioning screws in key slots. Install third screw in
remaining hole. Fully tighten all three screws.
(Figure 3)
4. Securely attach 9-pin connector from motor
assembly to wiring harness socket within switch cover
assembly. (Figure 4)
The color label on these two connectors must
correspond to each other.
5. Assemble the switch cover assembly onto the
switch cup support cover with three screws provided.
(Figure 5)
Periodic cleaning of your new ceiling fan is the only
maintenance necessary.
When cleaning, use only a soft brush or lint free cloth to
avoid scratching the finish.
Abrasive cleaning agents are not required and should be
avoided to prevent damage to finish.

How to Clean Your Ceiling Fan Blades

Periodic light dusting of the blades is recommended.
A feather duster will work best.
WARNING

Maintenance

Switch Cup
Support Cover
Switch Cover
Assembly
Switch Cover
Assembly
Do not use solvents when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of electrical shock.
Avoid using water, cleansers, or harsh rags, which
can warp and ruin the blades.
13
Figure 3
Motor
Assembly
Figure 4
Figure 5
Screws (3)
CAUTION