Haier AS09PBAHRA Mode D'emploi page 5

Parts and Functions
Indoor Unit
Inlet
Inlet grille
Horizontal flap
Vertical blade
(adjust up and down air flow
(adjust left and
Don't adjust it manually)
Display board
1
Signal receiver
Setting temp.display
2
Actual inlet grille may vary from the one shown in the
manual depending on the product purchased
Outdoor Unit
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
INLET
Please note the above picture is for reference only.
This may very depending on the unit purchased.
Air Purifying Filter
(inside)
Display
board
Emergency
Switch
Outlet
r ight air flow)
1
2
4
Remote controller
1 6
2
7
3
4
5
8
9
18
10
19
11
20
12
21
13
22
14
23
15
24
16
17 25
1. Mode display
Operation mode
AUTO COOL DRY FAN HEAT
Remote controller
2. Signal sending display
3. SWING display
4. FAN SPEED display
Display
circulated
AUTO
LO MED HI
5. LOCK display
6. TIMER OFF display
TIMER ON display
7. TEMP display
Healthy function is not available for some units.
Loading of the battery
4
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacles.
When an electronic-starter type fluorescent lamp, change- over
type fluorescent lamp or wireless telephone is installed in the
room, the receiver is apt to disturb the receiving of signals,
therefore the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batteries have been used up. Please change batteries.
If the remote controller does not operate normally during, please
remove the batteries and reload several minutes later.
Hint:
If the remote has not been used for a long period, change the
batteries and press the reset key.
2
8. Additional functions display
Supplemented
electrical
Operation mode QUIET SLEEP HEALTH TURBO
heating
Remote controller
9. QUIET button
10. HEAT button
11. COOL button
12. AUTO button
13. FAN SPEED button
14. TIMER button
15. HEALTH button
16. LOCK button
Used to lock buttons and LCD display
17. LIGHT button
Control the lightening and extinguishing
of the indoor LED display board.
18. POWER ON/OFF button
19. DRY button
20. TEMP button
21. SWING button
22. HOUR button
23. EXTRA FUNCTION button
Function: Sleeping---- Healthy
airflow position1--- Healthy airflow
position 2 --- Turbo --- Air sending
--- A-B yard --- Left and right air flow
24.CANCEL/CONFIRM button
Function: Setting and cancel to the
timer and other additional functions.
25. RESET button
When the remote controller appears
abnormal, use a sharp pointed
article to press this button to reset
the remote.
1
Remove the battery cover;
2
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
3
Be sure that the loading
e" + "/"-";
is in line with th