Reset Button - Learning Resources Time Tracker LER 6900 Mode D'emploi

To set AUTO TIMER:
1. Press MENU to scroll through: CLOCK, TIMER, AUTO TIMER.
2. When AUTO TIMER appears on screen, press ENTER to set or
change the time. (Note: if you already set the auto timer and you just
want to start it, press START. )
3. Screen shows: TOTAL TIME.
• To input the total amount of time: press ENTER to scroll forward to
hours, minutes, or seconds (press MENU to go backward).
• Use the ARROW
minutes, and seconds. Press ENTER when you are done.
4. Screen will show AUTO TIMER with the amount of time you input.
5. Press START to start the timer OR press MENU to return to digital
clock mode.
6. To STOP the timer, press and hold the MENU button.
STARTING THE TIMER
1. Once you have set the timer, press MENU until TIMER or
AUTO TIMER appears on screen.
2. Press the START button to start the timer.
3. To stop the timer at any point, press and hold the MENU button.
4. While the timer is running, you can press START to display how
much time is remaining in the lit section. Press START again to return
to total time remaining.
USING AN ADAPTER
Important note: When using an adapter (LER 6989, sold separately at
LearningResources.com), unplug the adapter from the Time Tracker
first, before unplugging the adapter from the wall. Unplugging the
adapter from the wall first will reset the unit and your programming will
be lost.
Use and Care Instructions
3
Do not submerge in water.
3
To clean, wipe gently with a damp, soft cloth.

RESET BUTTON

If the Time Tracker
or similar small object to push the reset button, located in the small
hole above the adapter jack.
buttons to input the amount of hours,
®
isn't working correctly, use the end of a paper clip
®
5