Zoef Robot Willem Manuel D'instructions page 75

6.1 Faults Description
Faults
The electrodes between the main body
and the charging base are not
contacted properly.
The robot can
not be charged.
The charging base is switched off while
the robot is switched on,which leads to
the loss of power.
The robot may be stuck by wires/cables
The robot is stuck
on the ground,hanging curtains or
during work.
obstacles around the carpets.
The robot detects that the power may
be not enough and automatically goes
The robot goes
back to recharge.
back to recharge
without finishing
The robot works at different speeds on
the cleaning work.
different floor types.For example,it
works longer on the wood floors than
on carpets.
The robot is not switched on and the
robot can not perform cleaning work as
scheduled when it is powered off.
The robot does not
The power level of the robot is too low
perform cleaning
to work.
work automatically
as scheduled
The robot is stuck or twined by
obstacles.
The remote controller is short of or out
of power.
Remote control
The robot is short of or out of power.
malfunctions
(effective range is
The infrared ray is blocked because the
5 m)
infrared emitter on the remotecontroller
or the infrared receiver in the robot is
contaminated.
Interference emitted by other devices
that exist nearby.
The drive wheel and the ground may slip due to the
robot climbing small steps, thresholds and door bars,
When the robot is
thus affecting the its judgment on the working
working, there is a
environment of the whole house.
missed sweep, the route
is chaotic, the deviation
Work on a waxed, polished floor or smooth floortile,
is reversed,and the APP
resulting in reduced friction between the drive wheel
side cleaning map shows
and the ground.
irregularities and is not
neat.
The wires, slippers, etc. placed on the ground affect
the normal operation of the robot.
Common Faults
Possible Reasons
Make sure that the electrodes between
the main body and the charging base
are properly contacted.
Keep charging the robot when it is not
working to better prepare for next
cleaning assignment.
The robot will try to get itself out
automatically.However,please help it
manually if it failed.
Charge the robot.
The length of working time varies
because of the complexities of room
environments,the amount of garbage
and different cleaning modes.
Turn on the robot.
Keep charging the robot when it is not
working to better prepare for next cleaning
assignment.
Turn off the robot and clean the dust
box.Then turn over the robot to clean its
components,such as wheels and
side brushes.
Change the batteries and install the
batteries correctly.
Make sure that the robot is switched on
with enough power for operation..
Wipe the infrared emitter on the remote
controller or the infrared receiver on the
robot with a clean cotton cloth.
Avoid using the remote controller near
other infrared devices.
It is recommended to close the door in the
area and clean the area separately. The
robot has the function of self-identification
single room. It will return to the starting.
It is recommended that you clean the floor after the wax
is air-dried.
Before the machine is working, please arrange the
scattered wires, slippers and other objects on the ground
to minimize the scattered objects on the ground.
35
Solutions