Sauder Shoal Creek Serie Instructions D'assemblage page 19

Step 14
The tabs should insert freely into the
1
slots. Gently tilt the DRAWER SIDES side
to side until the tabs slip into the slots.
D26
Groove
Insert the DRAWER SIDES (D26 and D27) at
å
an angle into the slot at each end of the
DRAWER FRONT (K).
3
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (Q2) to the DRAWER
å
FRONT (K). Tighten one HIDDEN CAM.
www.sauder.com/services
D27
K
Maximum
Arrow
210 degrees
Minimum
190 degrees
Q2
K
VIEW THE T-LOCK BOX VIDEO
With the palm of your hand, tap the
2
DRAWER BOTTOM down into the groove.
U n
fi n
s u
r f a
D26
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D981) into the grooves
å
in the DRAWER SIDES (D26 and D27) and
DRAWER FRONT (K).
4
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D26
Q2
Fasten the DRAWER BACK (D174) to the DRAWER
å
SIDES (D26 and D27) and DRAWER BRACE (Q2). Use
five BLACK 1-9/16" FLAT HEAD SCREWS (30S).
410420
i s h
e d
c e
D981
D27
K
30S
(5 used in this step)
D174
D27
Page 19