AENO EK7S Mode D'emploi page 5

ENG Electric smart kettle AENO EK7S is designed for heating and boiling
water at home and in the office.
Technical Specifications
Supply voltage: 220–240 V; Frequency: 50–60 Hz. Power: 1850.0–2200.0 W.
Dimensions (L×W×H): 212×162.3×262 mm. Capacity: 1.7 L. Water heating modes
with manual control: +40 °C, +55 °С, +80 °C, +90 °C, +100 °С, the range of
temperature adjustment when controlling through the application AENO:
40–100 °C. Function of maintaining the set temperature: up to 24 h. Emission
power: +20 dBm/100 mW.
Scope of Supply (fig. A)
Smart kettle AENO EK7S, stand (10), quick start guide, warranty card.
Limitations and Warnings
The kettle is intended for domestic use only. Before using for the first time,
make sure that the network parameters are in accordance with the
specifications in the technical data sheet. Do not use a damaged device or
device with a damaged power cord and/or plug. Do not allow the power cord
to come in contact with sharp edges or hot surfaces. Do not immerse the
power cord, power plug, kettle or stand in water or other liquids. Do not use
the device outdoors. Place the kettle on a flat, stable surface. To prevent
damage to the plastic components, install the device away from external
sources of heat and do not place the device near or on top of other electrical
appliances. Do not turn on an empty kettle to avoid damage. Use purified
water to reduce limescale buildup. Use the kettle for heating water only. Do
not allow children to use the kettle unsupervised. Do not open the kettle
while it is boiling or during the first few minutes after boiling. Be careful when
pouring boiling water, do not tilt the kettle with boiling water too sharply.
Make sure the lid is closed before you lift the kettle. Do not pour water below
the MIN mark and above the MAX mark on the inside of the housing. Use the
aeno.com/documents 5