Fire Safety - KIRAMI Original Breezy Mode D'emploi

Masquer les pouces Voir aussi pour Original Breezy:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40
© Kirami Oy, Finland
1. Use pipe tape in valve thread connection about 15
rounds thickening towards the base of the thread.
2. Install the valve in its place. Turn the valve MAX 10
times clockwise. Stop turning the valve in correct
position at once. Since turning back might leave the
tape sealing leaking. The correct position is marked
with upward arrow and word UP. The thread of the
valve is not meant to go all the way in.
3. Assembly of the plug.
4. Notice that the end of the bolt shall enter the matching
inlay in the valve.
5. Tighten the plug by turning the ring nut clockwise. Do
not overtighten, only turn half a turn at once until the
water stops running.
6. The plug is opened by turning the ring nut
counterclockwise and pulling it horizontally out from
the valve. If the plug seems to be stuck. Wait for a few
minutes so the plugs shape reverts. That way it will come out easier.
7. When water starts running, tighten the plug so it stays in.
Notice! Do not leave the plug tightened in for prolonged periods of time to ensure that it does not
get stuck in the valve body.
In case the tub is placed near buildings, e.g. the edge of a terrace, ensure that the chimney top is
located away from flammable materials. Remember to check the distance both sideways and
vertically in order to avoid the risk of fire. The distance from chimney top should be three metres to
any flammable material. A smaller distance is sufficient for the pipe of chimney. In case the chimney
is closer, use a separately insulated
chimney. When near a roof or when
running the chimney through the roof,
the end of the insulated chimney needs
to be one metre above the roof.
There should be no flammable material
located in front of and below the
furnace. In practical terms, this means
that an area of incombustible material,
such as concrete, sand, or a metal plate,
is needed in front of the furnace. The
stove will not heat up above the water
temperature as the stove is surrounded
by a water jacket. The chimney and door
of the stove will heat up, however. Ask more from a local fire authority.
INSTRUCTIONS FOR USE: Original Breezy hot tubs
23/72

FIRE SAFETY

05.01.2018
3 / 9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Breezy mOriginal breezy m

Table des Matières