Sauder North Avenue 423358 Mode D'emploi page 3

Step 1
Assemble your unit on a carpeted fl oor or on the empty carton to avoid scratching your unit or the fl oor.
å
NOTE: You should start each SCREW a few turns before completely tightening any of them.
å
Fasten the ENDS (G and H) to the UPPER SUPPORTS (I). Use four 1-3/16" ALLEN SCREWS (2) and the ALLEN
å
WRENCH (4).
Fasten the ENDS (G and H) to the LOWER SUPPORT (J). Use four 1/2" ALLEN SCREWS (3) and the ALLEN WRENCH (4).
å
NOTE: Be sure to square up the SUPPORTS (I and J) to the ENDS (G and H) before you completely tighten the SCREWS.
å
1-3/16" ALLEN SCREW
(4 used for the UPPER SUPPORTS)
2
I
I
G
These holes
must be here.
J
(4 used for the LOWER SUPPORT)
4
H
These holes
must be here.
3
1/2" ALLEN SCREW
Page 3