Programming Track Numbers - SOUNDMASTER CD9220 Mode D'emploi

1. Press to interrupt playback. - The elapsed playing time blinks.
2. To resume playback, press
Note: The set will return to the stop mode automatically after 60 seconds in pause mode.
SELECTING ALBUMS AND TRACKS ON MP3-WMA-CD
Selecting a track during playback
Briefly press or
current, previous or subsequent track.
- Playback continues with the selected track.
Searching for a passage during playback
1. Keep or
direction.
Searching is started and playback continues at a low volume.
2. Release the button at the desired passage.
•
Normal playback continues.
Selecting Album (only in MP3 mode)
Press the ALBUM▲ button to select the next album (if available).
You can store up to 20 tracks in a program. A single
track may be store more than once in the program.
1. While playback is stopped
2. Press PROG to enter programming.
PROG indicator and track number briefly on display.
3. Select a track with
4. Repeat step 2-3 to store all desired tracks
5. Press to start playback of your programmed tracks.
- PROG is shown and playback starts.
• To add additional tracks to your program, press
with step 2 and 3.
In the stop mode, you can review the programed track(s) by pressing
The display shows all the stored tracks in sequence.
Note:
If you try to store more than 20 tracks, start the program form the already first stored
title.
Clearing the program
While playback is stopped, press
- PROG indicator goes off and the program is cleared.
Note: The program will also be cleared if the power supply is interrupted, or if the CD -
player lid is opened, or if the set switches off automatical ly.
to again
once or several times to skip to beginning of the
pressed to find a particular passage in a backward or forward

PROGRAMMING TRACK NUMBERS

or then press PROG to store the track.
to clear program.
PAUSE
to stop playback and continue
6
CD9220 / English Instruction Manual
Track
Number
or
Program
Number
.