Search/Select The Receiver - Selve commeo Timer BT Mode D'emploi

GB
SELVE commeo radio
7.2.1. Search/select the receiver
Press the SELECT button of the commeo transmitter,
which has to be programmed or rather deprogrammed in
the receiver, for 3 seconds. The SELECT mode is started
and the commeo transmitter searches for all receivers
3 s
which were activated before. During the search, the status
LED of the transmitter flashes orange rapidly.
Red In case that no receiver could be found during the search,
this will be signalled with a red status LED at the commeo
transmitter and the SELECT mode is quit.
Green If one or more receivers are found, this is signalled briefly
with a green status LED at the transmitter. Afterwards, the
SELECT mode is displayed by a slow orange flashing of
the status LED and the transmitter automatically selects
the first receiver which was found.
By pressing the SELECT button several times for 1 sec-
ond, the requested receiver can be chosen. The currently
chosen rollershutter confirms the command with a short
movement (see the following diagram). The selected receiv-
1 s
er confirms the selection by a short movement. Select the
receiver which you want to connect with the commeo
transmitter or rather deprogram of the receiver.
SELECT mode
Receiver X
Receiver 1
SELECT 1 s
SELECT 1 s
Receiver 3
Receiver 2
46
SELECT 1 s
SELECT 1 s