Enerpac DGR-2 Fiche D'instructions page 8

Custom Units of Measure:
Allows a user to define a custom unit of
measure, user must enter the full scale value
of the desired reading, which can be done as
follows.
1. In Menu mode press
select "CUSTM", press
2. Select decimal point location:
The alphanumeric display shall show
"SELDP"
The fi rst screen to appear will show all
digits lit up as "5" and the rightmost
decimal point will blink (5 5 5 5.5)
unless the custom units feature had
been used previously. If it had been
used, the digits and decimal point
position shall correspond to the last
values set. Use the
keys to move the decimal point to the left
or the right. Once the decimal point is in
the desired position, press
lock it in place. When the key is released
the display reads "DIGIT".
3. Choose full scale value:
The alpha numeric display shall show
"DIGIT".
The next screen will continue to show
all digits as "5", with the leftmost digit
blinking and the decimal point fi xed in
the previously chosen position. However,
if the custom units feature has been
used previously, then the digits shall
correspond to the last value. The decimal
point remains at the location chosen in
▴
step 1. Press
value of the digit between 0-9.
➟
▴
▾
,
➟
|
|
.
➟
▴
▾
,
➟
| |
to
➟
▾
, to change the
Once the desired value is displayed,
press the
Now the next digit to the right will begin
blinking. Repeat this procedure for all
5 digits. When
released with the fi fth digit fl ashing,
,
the gauge will briefl y display "DONE"
then return to Measurement mode and
display "CUSTM" along with the numeric
readings to signify that the feature is use.
The user can optionally exit at any point
before the enter key is pressed with
➠
menu
by a
menu
step 2 or there is a menu timeout, then
whatever the user entered will be lost.
Note: The bar graph uses the factory default
setting when custom units are used.
Note: The magnitude of the value entered
when using the custom units feature can
significantly increase the noise on the
display, which can aff ect the zero and tare
functions as well as the stability of the
pressure reading displayed. If required,
consult factory for recommended limitations
on full scale input.
8
➟
| |
key to lock it in place.
| | ➟
is pressed and
. If the user exits the menu
➠
before completing