Enerpac DGR-2 Fiche D'instructions page 7

Tare Function:
Subtracts current pressure value from value
displayed in Measurement mode.
In Measurement mode, apply desired pressure
➟
and press to enable the tare function.
ZERO
The display will quickly fl ash "TARE", then the
"TARE" icon will be displayed and the pressure
reading will blink. The unit should now read 0.
➟
Press again to disable the tare function.
ZERO
The display will quickly fl ash "T OFF", then the
"TARE" icon will disappear and the pressure
reading will no longer be blinking. The unit will
now return to Measurement mode.
Programming:
To enter Menu mode
1. Press
menu
proceed to Programming mode.
▴
2. Press ,
programmable menu options.
3. When desired option is reached press
| ➟
|
to access that parameter.
4. If at any time you choose to EXIT the
Menu mode (or sub-menu mode) hold
➠
menu
saved.
Programmable Parameters:
Units of Measure:
1. In Menu mode, press
scroll to "UNITS", press
2. Choose engineering units by scrolling
➟
▴
▾
,
displayed, "PSI, BAR, kg/cm, mPa,
customer defi ned units (CUSTM)".
➟
| |
3. Press
to Measurement mode.
Note: Custom units programming, see
page 8.
7
➠
and release to
➟
▾
, to scroll through
. Your work will not be
➟
▴
▾
,
➟
| |
.
, until desired unit is
to select units and return
, to