Samsung WW8 T4 Serie Manuel D'utilisation page 54

Troubleshooting
Code
3C
UC
HC
1C
AC
8C
AC6
DC1
0
54 English
WW70T4020EE_04221H-00_EN.indd 54
Check the motor for operation.
• Try restarting the cycle.
• If the information code remains, contact a customer service centre.
The electronic control needs to be checked.
• Check if power is supplied properly.
• If the information code remains, contact a customer service centre.
Low voltage detected.
• Check if the power cord is plugged in.
• If the information code remains, contact a customer service centre.
High temperature heating check.
• If the information code remains, contact a customer service centre.
The Water Level sensor is not working properly.
• Try power off and restarting the cycle.
• If the information code remains, contact a customer service centre.
Check communications between main and sub PBAs.
• Try power off and restarting the cycle.
• If the information code remains, contact a customer service centre.
The MEMS sensor is not working properly.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a local Samsung service centre.
Check communications between the main and the inverter PBAs.
• Depending on the state, the machine may automatically returns to normal
operation.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a local Samsung service centre.
The Main Door lock/unlock is not working properly.
• Turn the machine off, and restart the cycle.
• If the information code remains, contact a local Samsung service centre.
The machine does not turn off automatically after the last spinning process, and
the "0" message remains.
• The machine operates normally without running the DRUM CLEAN cycle.
However, it is recommended to run the cycle for hygienic purposes.
Action
2022/8/17 16:21:25