Hunter QuietFlo 36095 Mode D'emploi page 3

®
Setting Up Your Air Purifi er
1. Remove your air purifi er from the box and take it out of the clear plastic protective bag.
2. Place your QuietFlo
3. Before turning the Air Purifi er 'on,' open the front grill.
• For Models 36095: To release the front grill, place your fi ngers behind the
tabs and pull forward. (Refer to Figure 1.)
• For Model 36127: To release the front grill, press the buttons on the side until the
front grill slides easily over the buttons. (Refer to Figure 2.)
4. The HEPA fi lter is already installed in the correct position, but you need to con-
fi rm that it is fully inserted. To remove, grasp the edge of the fi lter frame and pull
it forward. Notice the orientation of the fl aps and seal, which should be pressed
fi rmly into the fi lter opening.
5. The carbon pre-fi lter is mounted inside of the front grill with "hook" tape. Con-
fi rm that it covers the grill vents. (Refer to Figure 3.)
6. Place the fi lter installation reminder sticker on the inside edge of the front grill.
Circle the month and write the year of installation for the pre-fi lter and HEPA fi lter.
7. Replace the fi lter and front grill. Be sure that the bottom grill tabs are in position
fi rst, and then push the top of the grill forward until it is closed. The unit is now
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @
ready for normal operation. NOTE: This unit will not operate unless the door is
placed in the correct position.
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @
8. Plug the unit into a 220 ~ 240V electrical outlet.
HEPA Filter
Pre-Filter
Front
Grill
Figure 1 - Model 36095
41694_Purifier.indd 3
® Air Purifi er on a fi rm, fl at fl oor.
AIR PURIFIER PARTS
Tabs for
opening the
front grill
Figure 3
HEPA Filter
Pre-Filter
Front
Grill
Figure 2 - Model 36127
Hook Tape
Grill Vents
Hook Tape
3
Buttons for
opening the
front grill
5/7/04, 5:10:09 PM