Charging Process - FTX TRACER Mode D'emploi

CHARGING PROCESS

8
The supplied USB charger is exclusively for charging 2S
(7.4V) Li-ion or Li-Po battery packs only. Specification is
(Input: DC 5V/1A, Output: 7.4V/Max 1.3A)
Please follow the instructions regarding how to charge the
battery. Remove the battery from the model and connect
the pack to the white battery connector, with the USB
connected to your power source.
Red LED (Power LED) is always on solid as long as the
charger is connected to a power source (even if the battery
is not connected).
During charging the Red LED remains solid and the Green
LED (Charging LED) will flash slowly.
Green LED (Charging LED) becomes solid on after the
battery pack has been fully charged.
Alarm Indication: Red LED (Power LED)
Flashes rapidly which means the battery pack is damaged
or over-discharged and not able to take charge. If this is the
case please replace battery.
(Note: Your model is already bound from the factory)
FTXTracerMTManual.indd 8 FTXTracerMTManual.indd 8
GETTING TO KNOW YOUR RC VEHICLE
CHARGING
8
21/10/2021 14:43 21/10/2021 14:43