Troubleshooting; Spare Parts - PLYMOVENT MDB-2/COMPACT Manuel D'installation Et D'utilisation

To reset the timer, proceed as follows.
• Push and hold the
MANUAL CLEANING
for 10 seconds .
18
6.4 Precoat (PREcO-N) / cART-D and cART-c
only (option)
• Refer to section 4.8 for the precoat procedure.
7

TROUBLEShOOTINg

If the unit does not function (correctly), consult the checklist
below to see if you can remedy the error yourself. Should this
not be possible, contact your supplier.
WARNINg
Obey the safety regulations that are written in
chapter 3 when you carry out the activities below.
Symptom Problem
MANUAL No manual
CLEANING cleaning
button cannot possible.
be activated.
No automatic No filter
offline filter cleaning.
cleaning
takes place.
The fan does The unit does
not start. not function.
The fan does -
not stop
when the
external
device is off.
The fan Extraction
makes a capacity
humming insufficient or
sound, but no extraction
does not run. at all.
18. The red light (ref. Fig. 5.1E) stops blinking.
0000104046/150915/0 MultiDust Bank COMPACT
button (ref. Fig. 5.1B)
Possible Solution
cause
Manual cleaning Do not activate
is not possible manual cleaning.
within the first
30 running
hours of the fan
(after filter
replacement in
case of CART-D
or CART-C with
PRECO-N).
In case of -
PRECO-N:
filter cleaning is
not activated
within the first
30 running
hours of the fan
(after filter
replacement).
In case of no Remove the jumper
PRECO-N: (refer to section
jumper in 4.6.1).
control panel
installed
erroneously.
No mains Connect the mains
voltage. voltage.
The mains Repair or replace
cable is the mains cable.
defective.
Loose contacts. Repair the contacts.
Motor defective. Repair or replace
the motor.
Start/stop Install a start/stop
device is not device that is able
compliant with to receive a 0-24
the external VDC signal.
device.
The fan delay Wait.
time is active.
Motor uses 3 Repair the phase
phases instead connection.
of 2.
Symptom Problem
Poor The unit does
extraction not function
capacity. properly.
Pollution of
the facility.
No filter
cleaning.
Hissing No filter
sound. cleaning
White light Wrong status
is indication.
POWER ON
off, but fan is
running.
Green light Wrong status
indication.
FAN RUNNING
is off, but fan
is running.
8

SPARE PARTS

8.1 MDB-cOMPAcT
The following spare parts are available for the product (refer to
exploded view Fig. VII on page 92).
Article no. Description
general
0000100297 CART-PTFE/10 / Filter cartridge
0000100351 TEV-AV/79 / Vibration dampers
0000100353 CART-C / Filter cartridge
0000100354 CART-E / Filter cartridge
0000100356 CART-D / Filter cartridge
0000101373 PRECO-N / Precoat material (1 kg/2.2 lbs.) [not
shown]
0000102315 CART-MB / Filter cartridge
0000102411 Drain valve ½ inch [not shown]
0000102584 Lock kit for CART filter cartridge [not shown]
0000102598 Star knob M12
0000102666 Cover plate for filter cartridge CART
0000102675 Filter cartridge holder
0000103138 Deflector plate
0000103148 Square key
0000103150 Magnetic valve, incl. 24V DC coil and 3 m (10 ft.)
cable
0000104642 CART-PTFE/15 / Filter cartridge
0069002280 PRECO-N / Precoat material (14 kg/30.9 lbs.) [not
shown]
0806010120 Handle
Possible Solution
cause
Inverted Change the
direction of direction of
rotation of the rotation.
motor.
Clogged filter Replace the filter
cartridges. cartridges.
Filter Replace the filter
cartridge(s) cartridges(s) or
ripped or place them
placed correctly.
incorrectly.
Loose Repair the
compressed air compressed air
connection. connection.
No compressed Repair the
air available or compressed air
air pressure too supply.
low.
Magnetic Replace the
valve(s) magnetic valve(s).
defective or
worn.
Magnetic Replace the
valve(s) magnetic valve(s).
defective or
worn.
Indicator light Replace white light.
is broken.
Indicator light Replace green light.
is broken.
19
19
19
19
19
19
EN - 14