Publicité
Step 10
Fasten three CARD HOLDERS (21M) to the SHELF
å
MOLDING (L). Use six SILVER 1/2" MACHINE
SCREWS (38S) as shown to the right.
Separate the CARDS on the CARD SHEET (38M) and insert
å
them into the CARD HOLDERS (21M).
Fasten the SHELF MOLDING (L) to the SHELF (F). Tighten
å
four HIDDEN CAMS.
Fasten the remaining END (A) to the TOP (D), BOTTOM (E),
å
and SHELF (F). Tighten six HIDDEN CAMS.
1
2
Maximum
210 degrees
Minimum
190 degrees
Page 14
SILVER 1/2" MACHINE SCREW
(6 used for the CARD HOLDERS)
E
Arrow
These holes must be
closer to the top edge.
38S
The open slots on the card
holders must be facing up.
L
F
417653
38M
21M
L
These edges are almost even.
D
A
l e s
h o
u t
h o
w i t
c e
r f a
S u
www.sauder.com/services
Publicité
