Ariston 3318586 Instructions De Montage Et D'utilisation page 16

timer mode (with remote control only)
GB
The timer mode operates according to
the heating time schedule set on the
SENSYS system interface (where pre-
sent).
Press the operating mode button until
the arrow " " appears on the display
near the symbol " "
Timer-based room temperature
adjustment
During the TIMER mode, it is possible to
temporarily modify the set-point tem-
perature (20°C - 16°C) - set on the SEN-
SYS system interface - used in the time
schedule.
Press the adjustment buttons "
" to set the desired room temperature
value.
The set value will start fl ashing on the
display until the symbol " " appears,
alongside the desired time value (3h de-
fault setting) during which the modifi ca-
tion will be maintained.
Press the adjustment buttons " "
to set the duration of the modifi cation,
which can vary between 1 hour (mini-
mum) and 24 hours (maximum).
The set value will fl ash on the display
and, after a few seconds, the display will
once again visualise the detected room
temperature.
Once the desired time is set, the device
will start the countdown after which it
will return to the pre-set set-point tem-
perature.
Press the operating mode button to can-
cel the timer-based modifi cation of the
set-point value, thereby restoring the
manual mode.
16