Caracteristiques Techniques - Alpes Inox 2010 Serie Guide Pour L'installation

open
closed
ouvert
fermé
gasket
garniture
1
2
TECHNICAL AND STRUCTURAL FEATURES
The whole basin and sink are made of 19/10 chrome-nickel stainless
steel with "silver" finishing.
Underneath the basins it is fire-welded an heat and sound insulation
material to keep the water warm inside the bowls and to deaden
the noise caused by water and dishes.
The drain knob controls the opening and closing of the plug by
means of a stainless steel cord in order to avoid to touch the water
with hands.

CARACTERISTIQUES TECHNIQUES

ET DE CONSTRUCTION
Tout le bac et l'évier sont construits en acier inox au nickel-
chrome 19/10 avec finissage "argent".
Sur l'envers des bacs, en dessous, est appliqué à chaud un
Fig. 1
matériau isolant thermo-acoustique qui permet de maintenir
la chaleur de l'eau à l'intérieur des bacs et d'amortir les bruits
causés par l'eau et la vaisselle.
La poignée commande l'ouverture et la fermeture du bouchon
à travers un cordon en acier inox pour éviter de devoir immerger
les mains dans les bacs.
INSTALLATION
Unpack the bowl or the sink.
The elements to be installed must be inserted in the appropriate
containers, whose cutouts must be sized as specified in the
Fig. 2 instructions diagram. Before proceeding with installation, apply
seal.
Secure the top of the unit by gradually tightening the hooks (fig.
1 - 2).
Do not tighten the fixing screws more than is necessary. Do not
use electrical or air owered screw drivers.
Fix the overflow pipe after fitting the washing element into the unit,
as shown in the following figure 3:
- fit the upper end of the overflow pipe over the overflow holes in
the basin
- fit the lower end of the overflow pipe into the connector under
basin
- secure the upper end of the overflow pipe using the supplied
screw
- recess the knob for opening/closing the plug into the worktop.
2