Accessories - Triton T20 Instructions D'utilisation Et Consignes De Sécurité

Accessories

• A range of accessories, including a 2Ah battery (T20B), 4Ah high capacity battery
(T20HCB), drill and screwdriver bits is available from your Triton dealer. Spare parts can be
purchased from your Triton dealer or online at www.toolsparesonline.com
Maintenance
• This tool is manufactured using class-leading components and makes use of the latest
in intelligent circuitry that protects the tool and its components. In normal use it should
provide a long working life
Cleaning
• Keep your machine clean at all times. Dirt and dust will cause internal parts to wear
quickly, and shorten the machine's service life. Clean the body of your machine with a
soft brush or dry cloth. If available, use clean, dry, compressed air to blow through the
ventilation holes
Troubleshooting
Problem
Red charging LED does not illuminate and battery
not charging
Battery pack has low capacity
Drill cannot be switched on (trigger switch does
not move)
Drill does not start when on/off trigger switch is
depressed
Screws do not reach deep enough into the
workpiece
GB
Screws are driven too deep into the workpiece
surface
During masonry drilling the drill bit does not
penetrate the wall
8
Storage
• Store this tool and its accessories after use in its case, in a dry, secure place out of the
reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, batteries or other waste electrical and electronic equipment
(WEEE), with household waste
• Contact your local waste disposal authority for information on the correct way to dispose
of power tools and batteries
Possible cause
Battery not fully seated
Charger not powered
Battery not being fully charged
Battery pack has been charged over 100 times
and capacity has started to reduce
The forward/reverse switch may be in the middle
('locked') position
Battery completely discharged
Defective battery
Machine defective
Not enough torque; torque clutch setting too low
Low battery voltage
Too much torque; torque clutch setting too high
Unsuitable or blunt drill bit
Drill bit too large
Drill not set to hammer mode
Solution
Clean battery socket of charger
Recheck mains connection
Charge the battery until the charger indicates a
full charge
This is normal for batteries. Contact your Triton
dealer to purchase a replacement battery
Slide the forward/reverse switch either to the
left or right
Recharge battery or replace with a fully
charged battery
Replace battery
Contact your Triton dealer or authorised
service centre
Choose a higher torque setting
Recharge battery or replace with a fully
charged battery
Choose a lower torque setting
Replace drill bit with a new high quality masonry
drill bit
See 'Specifications' for maximum
drilling capacities
Rotate mode selector to switch the machine into
hammer drill mode (see 'Mode Selection')