Table des Matières
Publicité
Warnings:
Warning:
Do not plug in the power supply until the outside antenna cable is attached to the Sleek.
RF Safety: The Sleek cradle/signal booster must be installed with a separation of at least 8 inches
Warning:
from all persons and must not be located in conjunction with any other antenna or signal booster.
RF Safety: The FCC requires that a cell phone with cradle attached may only be used
Warning
with the cradle mounted as illustrated in this installation guide. A cell phone held near the
ear must be without the cradle attached.
Warning:
RF Safety: The Outside Antennas authorized for use with this signal boosters are shown on
page 1 of this guide. Other antennas may be used, but only in fixed installations when located
outside of a building or structure (not in mobile/ portable installations), provided that:
(a) antenna location ensures at least a 30 inch separation distance from all persons,
(b) antenna gain less cable loss does not exceed 15 dBi, and
(c) such antennas are not operating in conjunction with any other antennas, or transmitting
devices.
Warning:
DO NOT use phone covers that have chrome or any other metallic surface. It may block cellular
signals
All Wilson Electronics products are protected by Wilson Electronics 30-day money-back guarantee. If, for any reason, the performance of any product is not acceptable, simply
return the product directly to the reseller with a dated proof of purchase.
Wilson Electronics signal boosters are warranted for one (1) year against defects in workmanship and / or materials. Warranty issues may be resolved by returning
the product directly to the reseller with a dated proof of purchase.
Signal boosters may also be returned directly to the manufacturer at the consumer's expense, with a dated proof of purchase and a Returned Material Authorization (RMA)
number supplied by Wilson Electronics. Wilson Electronics shall, at its option, either repair or replace the product. Wilson Electronics will pay for delivery of the repaired or
replaced product back to the original consumer within the continental United States.
This warranty does not apply to any signal boosters determined by Wilson Electronics to have been subjected to misuse, abuse, neglect, or mishandling that alters
or damages physical or electronic properties.
RMA numbers may be obtained by phoning Technical Support at 866-294-1660.
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of this device.
Disclaimer:
The information provided by Wilson Electronics, Inc. is believed to be complete and accurate. However, no responsibility is assumed by Wilson
Electronics, Inc. for any business or personal losses arising from its use, or for any infringements of patents or other rights of third parties that may result from its use.
Copyright © 2011 Wilson Electronics, Inc. All rights reserved.
About Wilson electronics
Wilson Electronics, Inc. has
been a leader in the wireless
communications industry for over
40 years. The company designs
and manufactures signal boosters,
antennas and related components
that significantly improve cellular
telephone signal reception and transmission in a wide variety of applications, both mobile (marine, RV, &
vehicle) and in-building (homes, offices & M2M).
With extensive experience in antenna and signal booster research and design, the company's
engineering team uses a state-of-the-art testing laboratory, including an anechoic chamber and network
analyzers, to fine-tune antenna designs and performance. For its signal boosters, Wilson Electronics
uses a double-shielded RF enclosure and cell tower simulators for compliance testing.
All products are engineered and assembled in the company's 55,000-square-foot headquarters in St.
George, Utah. Wilson Electronics has product dealers in all 50 states as well as in countries all over the
world.
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
30-Day Money-Back Guarantee
1-Year Warranty
6
6
Publicité
Table des Matières
